Need help?Do you have a question about the Sansui AU-777A and is the answer not in the manual?
General| Type | Integrated Amplifier |
|---|---|
| Damping Factor | 40 |
| Input Sensitivity | 180mV (line) |
| Dimensions | 400 x 125 x 330mm |
| Weight | 11.2kg |
| Speaker load impedance | 4 - 16 ohms |
| Total Harmonic Distortion (THD) | 0.1% |
| Signal to Noise Ratio | 85 dB |
| Channel separation | 50 dB |
| Output | Speaker |
| Semiconductors | Transistors |
| Frequency Response | 10Hz to 30kHz |
Describes the Mode switch for stereo/mono and the Input Selector for choosing audio sources.
Guide for connecting one or two sets of speakers to the amplifier's terminals.
Instructions for connecting record players and listening to stereo or monophonic records.
Instructions for connecting, recording, playing, and monitoring with tape recorders.
How the amplifier enables an electronic crossover system for multi-amplifier setups.
Common causes and solutions for hum and howling noises experienced with the amplifier.
Details on replacing power and quick-acting fuses and troubleshooting blown fuses.
Technical specifications for the amplifier's power output, distortion, and frequency response.
Detailed specifications for the pre-amplifier section, including input sensitivity and noise levels.
A high-level block diagram illustrating the signal flow and main sections of the amplifier.
Identifies key test points and outlines the procedure for adjusting the main amplifier section output.
Details the steps for adjusting the DC bias current in the main amplifier section.
To Next Page
