Need help?Do you have a question about the Sansui AU-777 and is the answer not in the manual?
General| Total Harmonic Distortion | 0.8% |
|---|---|
| Signal to Noise Ratio | 85dB |
| Weight | 12kg |
| Speaker Load Impedance | 4Ω to 16Ω |
| Frequency Response | 20Hz to 20kHz |
| Input Sensitivity | 2.5mV (MM) |
| Channel Separation | 50dB |
| Type | Solid State |
| Power Output | 25W per channel into 8Ω (stereo) |
Troubleshooting symptoms and causes applicable to all audio sources.
Specific troubleshooting guidance for record players and tape decks.
Troubleshooting for various input sources like Tuner, AUX.
Component layout and identification for the Head Amplifier circuit.
Component layout and identification for the Pre-Amplifier circuit.
Details on selector switch positions for various audio functions.
Details on selector switch positions for speaker output selection.
Step-by-step procedure for adjusting main amplifier output levels.
Step-by-step procedure for adjusting main amplifier current.
Visual diagram of component placement on the upper chassis.
Visual diagram of component placement on the back panel.
Visual diagram of component placement on the lower chassis.
To Next Page
