Sansui RA-700 - Operating Procedures

To
Reverberate
Sound
From
Any
Pro-
. gram
Source—Record
Player,
Tuner
or
Microphone—Except
Tape
Deck
1. Set the Tape Monitor switch on the receiver
(or control amplifier) to its PLAYBACK or
ON position.
2. Turn the Tape Mode selector on the RA-
__ 700 to its OFF position.
. Depress the Reverberation On button.
4. Adjust the Reverberation Time control to
‘he desired reverberation.
To Reverberate Sound From or
Through the Tape Deck
Playback
1. Set the Tape Monitor switch on the receiver
(or control amplifier) to its PLAYBACK or
ON position.
2. Turn the Tape Mode selector on the RA-
700 to A or B depending on which jacks are
being used for playback.
3. Depress the Reverberation On button.
4. Operate the tape deck in the playback
mode.
5. Adjust the Reverberation Time control to
the desired reverberation.
- Recording
1. Set the Tape Monitor switch on the receiver
(or control amplifier) to its PLAYBACK or
ON position.
2. Turn the Tape Mode selector on the RA-
700 to A or B depending on which jacks are
being used for recording.
3. Depress the Reverberation Record button.
4. Operate the tape deck in the recording
mode.
’ 5. Adjust the Reverberation Time control to
the desired reverberation.
. Notes:
« If the Reverberation On button is depressed
during the recording process, the original pro-
gram can be recorded without reverberation
nn
et
TS
SS,
while the reverberated sound comes from the
speakers.
If the Reverberation Off button is depressed
during the recording process, no reverberation
is added to the sound of the recording nor to
the sound from the speakers.
Dubbing
1. Set the Tape Monitor switch on the receiver
(or control amplifier) to its PLAYBACK or
ON position.
2. When recording from the tape deck A to
the tape deck B, turn the Tape Mode selector
to APB; when recording from the B to the A,
turn the selector to BRA.
3.
Depress
the
Reverberation
Record
button.
4.
Operate
one
tape
deck
in
the
playback
mode
and
another
in
the
recording
mode.
5. Adjust the Reverberation Time control to
the desired reverberation.
Note: If you want not to add reverberation
during the dubbing process, depress the Rever-
beration Off button. If the Reverberation On
button is depressed during the dubbing process,
the original tape can be recorded without re-
verberation while the reverberated sound
comes from the speakers.
Monitoring
If your tape deck has its own preamplifier as
well as separate recording and playback heads,
you can monitor the tape instantly after the
recording is made and while the recording is
still in progress. For use with a two-head tape
recorder which can pick up a signal before the
recording is made, you can listen to it as well.
If a two-head tape recorder which does not
employ this arrangement is used for recording,
not playback, the Tape Monitor switch on the
control amplifier (or receiver) should be set to
its SOURCE or OFF position, otherwise no
sound comes from the speakers.