Need help?Do you have a question about the Sansui 4000 and is the answer not in the manual?
General| Total Harmonic Distortion | 0.8% |
|---|---|
| Damping Factor | 30 |
| Channel Separation | 50dB |
| Speaker Load Impedance | 4Ω to 16Ω |
| Frequency Response | 20Hz to 20kHz |
| Input Sensitivity | 2.5mV (MM), 150mV (line) |
Diagrams illustrating key test points for unit calibration and troubleshooting.
Step-by-step guide for calibrating the FM receiver section for optimal performance.
Detailed steps for aligning the FM stereo multiplex decoder circuits.
Instructions for performing alignment on the AM receiver section of the tuner.
Procedure for adjusting the quiescent current in amplifier stages.
Steps to adjust audio output levels and ensure proper signal clipping.
Procedure for setting the DC protection circuit threshold.
Component list and schematic for the Equalizer Amplifier module.
Component list and schematic for the Tone Control module.
Component list and schematic for the High-Low Filter module.
Component list and schematic for the Muting module.
Component list and schematic for the Accessories module.
Component list and schematic for the Protector module.
Component list and schematic for the Ripple Filter module.
Component list and schematic for the FM IF Amplifier module.
Component list and schematic for the FM Multiplex Stereo Decoder module.
Component list and schematic for the AM IF Amplifier module.
Component list and schematic for the Driver Amplifier module.
To Next Page
