Sansui RA-700 - Voltage Adjustment and Placement

Ne ee!
Voltage Adjustment ACCESSORIES
+ To reach the voltage selector, remove the two
1, OPERATING INSTRUCTIONS.......... 1
screws from the nameplate on the rear panel
2. OPERATING SHEET..........-++-.+-- 1
and then remove the nameplate. The voltage S SeGNNE STING Coane Wal
t i i t - :
aelecton
aces
it
Dosiule
te
/eperate
ine
PIN-PUGSS
nfsc2-
ate
atuenceer
eats
4
700 at the correct volt in any area. The volt
has been pre-adjusted at the factory, but can Operating Instructions Stock No. 9208670
be easily readjusted as follows:
Set the arrow on the voltage selector plug to
the required volt: 100, 117, 220 or 240 volts.
2. The power fuse should also be changed
whenever the a.c. line voltage is changed. For
100-117 volt operation, a 0.5 ampere fuse is
required. For 220-240 volt operation, the fuse
should be changed to a 0.3 ampere fuse.
Note: The voltage selector can be also used to
eliminate the trouble caused by the consider-
able voltaege fluctuation. In this case, it should
be set to the peak voltage.
Placement.
Your RA-700 may be placed in any position
where it is convenient to reach. But we recom-
mend to place it away from the speakers be-
cause unnatural reverberation or booming noise
may be caused.