Sansui RG-710 - Page 9

MIC MIXING
Yet = EL MIC
ce: sm KEYBOARD
Playback with reverb effects added
Sounds from cassette tape, microphone, and all other program sources
can be modified to achieve various sound and tonal changes by adding
the three special effects reverberation, reverberation equalization, and
M
1
ULTIDIMENTION.
. To add reverberation effects to tape or record sounds, press the LINE
reverb switch. To add reverberation effects to microphone or key-
board sounds, press the MIC reverb switch. When both switches are
pressed, reverberation effects will be added to the sounds from both
sources.
. While listening to the playback sound, slide the REVERB DEPTH con-
trol to vary the amount of reverberation effect added. The sound dis-
play pattern will change in response to the added effect.
. By adjusting the position of the REVERB EQUALIZER controls, the
reverberation effect of specific frequency ranges can be selectively
increased or decreased. When the reverb effect in the low sound
ranges is increased, a soft sound effect is produced, while increas-
ing the reverb effect in the high ranges will produce a more metalic
sound.
. To add MULTIDIMENSION effects, set the MULTIDIMENSION switch
to ON, and adjust the control to achieve the desired effect. The
breadth of sound is emphasized as the control is rotated clockwise.
[REVERB EQUAL (ZER———
s Ly CJ
6OH2z 18OHz 540Hz 1100Hz2200Hz
MULTIDIMENStON ——7
t
mON Ye
Bs
OLOFF mw! Max