Sansui SR-929 - Page 22

20
Amplifier
Amplificateur
Verstarker
45 rpm record adaptor
Adaptateur de disque 4 45t/mn
} Adapter fir 45 er Schaliplatten
Mounting dust cover '-
You can mount the dust cover by pushing it as illustrated at left.
Connections with amplifier
The output cables supplied with your turntable are of the low-
capacitance type, ‘suitable especially for CD-4 record playback. These
cables should be used to connect the turntable with the “PHONO”
terminals on your amplifier; cable for the right channel is red-colored
and the other for the left is not, to facilitate correct connection.
Grounding ©
There's a viny!-coated cable running along the output cables. This is the
grounding cable to be used. for connection between the ‘‘GND"”
terminals on your turntable and amplifier. Grounding your unit should
reduce hum noise. tf however the contrary occurs, disconnect the cable.
Cabinet height adjustment
You can adjust the height of each of the insulating feet. Be sure to
adjust the height so that the motor board is kept strictly horizontal.
45rpm record adaptor
Take care not to lose the supplied 45rpm (EP) record adaptor when not
in use.