Need help?Do you have a question about the Sansui FR-4060 and is the answer not in the manual?
Describes the automatic operation sequence of the turntable, including start, auto-in, and auto-return functions.
Details the steps for manual operation, including stylus placement and lift-up.
Explains how the tonearm moves manually and the effect of the lifter lever on disk interaction.
Guides on balancing the tonearm and setting the correct stylus pressure using the main weight.
Explains how to adjust the bias control to match the stylus pressure setting.
Details adjusting screws for precise auto-in and auto-return timing for 25/30cm records.
Provides instructions for adjusting auto-return timing specifically for 17cm records.
Covers adjusting the lift-down speed for manual operation to match auto operation.
Presents an exploded view and parts list for the top section of the turntable mechanism.
Shows an exploded view and parts list for the bottom section of the turntable mechanism.
Step-by-step guide for removing and installing a new cartridge, including lead connection.
Instructions on how to replace the capstan, ensuring correct belt alignment and tension.
Recommends lubrication frequency and procedure, cautioning against oil on the belt or capstan.
Explains how to select the correct voltage (120V or 240V) for the unit based on local electricity.
To Next Page
General
