What to do if no change in display when pressing Programming Keys on Sanwa ExzesX?
If there is no change in the display when you press the Programming Keys on your Sanwa Remote Control, it means the Key-Lock switch is ON. Turn the Key-Lock switch OFF to enable changes to the display.
Why don't Lap Timer and Interval Timer function on Sanwa ExzesX?
If the Lap Timer and Interval Timer on your Sanwa Remote Control do not function, it is possible that the timers are turned OFF. Ensure that you turn the timers ON to enable them.
How to fix Sanwa ExzesX sticks when they do not center?
If your Sanwa Remote Control sticks do not center, it's likely that the spring tension is too loose. Try tightening the spring tension to resolve this issue.
General| Telemetry | Yes |
|---|---|
| Display | LCD |
| Frequency | 2.4GHz |
| Compatible Receivers | RX-451 |
| Battery Type | AA |
| Modulation | FHSS (Frequency Hopping Spread Spectrum) |
Precautions for using the 2.4GHz frequency band to avoid interference.
Important operating precautions for the transmitter.
Important operating precautions for the receiver.
Details on control sticks, dial, buttons, trims, spring tension, and gimbal angle.
Instructions for installing batteries into the transmitter.
Guidance on connecting and mounting the receiver in the model.
Information on using rechargeable Ni-Cd/Ni-MH or Li-Po/Li-Fe batteries.
Procedure to adjust the steering servo travel relative to stick movement.
Adjusting servo travel for steering in left and right directions.
Adjusting servo travel for throttle high and brake.
Adjusting steering response curve for mild to quick feel.
Adjusting throttle response curve for high-torque or high-grip conditions.
Adjusting steering response curve for mild to quick feel.
Adjusting throttle response for high-torque or high-grip conditions.
Adjusting the transit speed of the steering servo.
Adjusting the transit speed of the throttle servo for braking.
Setting the point at which ALB function activates.
Controlling the amount of brake movement for ALB.
Setting the delay before ALB activates after reaching the point.
Controlling how quickly the brake pulsates.
Function to improve starts and acceleration stability.
Procedure to select and load stored model programming data.
How to name saved models, up to 12 characters.
Procedure for copying or clearing programming data between models.
Correcting servo neutral trim without affecting End Points.
Electronically switching the direction of servo travel.
Holding throttle open for easier engine starting.
Performing various functions like engine cut or steady idle.
Mixing brake servos for models with separate front and rear brakes.
Enabling the 3rd channel brake servo function.
Creating custom mixes to control multiple functions simultaneously.
Detailed steps for programming the first compensation mix.
Automatically setting servos to a position if signal is lost.
Programming fail-safe positions for individual channels.
Setting the brake servo position when Fail Safe activates.
Activating and setting a custom receiver voltage for throttle Fail Safe.
Recalibrating control stick endpoints and neutral positions.
To Next Page
