Sanxin PC5 - Technical Specifications

e) TDS factor (P5):
Adjust TDS factor between 0.40~1.00. Factory default setting is 0.71.
f) Salinity and temperature unit (P6 and P7):
Salinity unit: ppt and mg/L, Temperature unit: ℃ and ℉. Factory default setting is ppt and ℃.
g) Factory default setting (P8):
Select “Yes” to recover instrument calibration setting to theoretical value (pH and conductivity),
parameter setting returns to initial value. This function can be used when instrument does not work
well in calibration or measurement. Calibrate and measure again after recover the instrument to
factory default status.
10. Technical Specifications
pH
Measuring range
-2.00 ~ 16.00pH
Resolution
0.01pH
Accuracy
±0.01pH
Calibration points
1 ~ 3points automatic calibration
Automatic temperature
compensation
0 ~ 50℃
Cond.
Measuring range
0~200.0μS, 0~2000μS, 0~20.00mS
Resolution
0.1/1μS, 0.01mS
Accuracy
±1%F.S
Calibration points
1 ~ 3points automatic calibration
TDS
Measuring range
0~100.0ppm, 0~1000ppm,
0~10.00ppt
Salinity
Measuring range
0 ~ 10.00ppt
Temp.
Measuring range
0 ~ 50℃
Resolution
0.1℃
Accuracy
±0.5℃