7
Note:
• Press the ANTI SHOCK/ROLL but-
ton to turn the anti rolling shock
function off.
disappears. Press
the button again to turn it on.
• Sound may skip or mute for a few
seconds when you press the ANTI
SHOCK/ROLL button during play.
• Playing may stop when the unit
gets strong shock even when the
anti rolling shock function is on.
Anti rolling shock function
In the previous anti-shock function, when
skips occurred while available memory
runs out, then the sound would suffer
some interruption.
The new anti rolling shock function is
designed to prevent skipping to the great-
est extent possible instead of supple-
menting the skipped portion of the sound.
This is achieved by expanding the
memory capacity, and in addition full
attention has been given also to increas-
ing the unit's signal reading capability.
Moreover, consideration has been given
to eliminating the basic causes of
skipping, both from the standpoint of hori-
zontal shock and vertical shock.
Use this function when listening during
walk or playing in a car.
When the PLAY/PAUSE button is pressed
first time, the anti rolling shock function
turns on automatically. appears on
the display. The changes to
when the buffer memory is full of next 45
seconds music data.
BEFORE OPERATION
12
PROGRAMMED PLAY
Up to 24 tracks on a disc can be pro-
grammed for play in any order.
1. Press the PROG button during stop.
2. Press the e or f SKIP/SEARCH
button to select a track.
3. Press the PROG button.
4. Repeat steps 2 and 3 to programme
tracks.
5. To check the programme contents
after all tracks have been
programmed, press the PROG but-
ton repeatedly. The programmed
track numbers sequentially appear
on the display.
• The check will not operate if 24 tracks
have been programmed.
6. Press the PLAY/PAUSE button to
start programmed play.
• To cancel programmed play, press
the STOP button twice.
Track number
Programme number
CDP-4100CR/AU-final 2/3/05, 10:50 AM8
To Next Page
