Sanyo DC D30 - Page 9

MECHANISM REMOVAL (CD)
(4) Lubricating the base lever
Apply grease (FLOIL G-474B) to the
CEMEDINE
1575
aan
"gs |
BASE CHASSIS
PULL UP
SPRING
(6) Arranging and securing the leads
(5)
1)
2)
3)
Lubricating the pickup sled gear and clutch gear
Apply grease (FLOIL G-474B) around the entire circumference
of the lower gear of the pickup sled gear (CM12), as shown
in the figure ( ea).
Apply grease (G- 333) around the entire circumference of the
outer clutch gear (CM9).
Apply grease (FLOIL G-474B) to the #8 part of the outer
clutch gear (CM9) where it makes contact with the inner
clutch gear (CM8).
PICKUP SLED GEAR
(}
1) As shown in the figure, set the pickup (CM52) at a position on the innermost circumference of the compact disc, and pass the
leads from the pickup (CM52) and spindle motor (CM48) through pin (a) of the chassis (CM39).
Arrange the leads from the load-
ing/sled motor (CM38) and sensor switch (micro switch) (CM26) by passing them through point (b) in the chassis (CM39). After
securing the leads with the lug (CM41), check that the pickup (CM52) moves smoothly without the leads interfering with its
movement.
2) If no problems arise in the @ check, secure the points shown in the figure using a bonding agent (Cemedine #575).
FLOIL(G-474B)
par BE NOT SLACK
TO CN101 CD PCB
NOTE THE LUG PORTION
ISS] RSXSSSSA ASS ASSSSSSSSSSSY
CUSHION