Sanyo DP26640 - Setup

– 6 –
MECHANICAL DISASSEMBLY
CAUTION: This LCD TV uses several different kinds of screws. Using the correct screw is necessary to
prevent damage. Lead wires must be redressed to their previous locations after servicing.
B
B
STAND REMOVAL
Position TV face down on a padded or cushioned surface
to protect the screen and finish.
Remove 4 screws (B: 6X16) to take the stand off.
BACK CABINET REMOVAL
1. Remove the screws shown in figure.
(C:3x14, 10 pcs.; D4x8, 4 pcs.; A3x6, 1 pcs.)
2. Lift the back cabinet and remove the lead wire connector.
3. Take the back cabinet off.
C
C
D
D
C
D
C
C
C
C
C
C
C
D
A
Main BoardPower Unit
C
C
C
C
C
C
C
C
C
C
C
C
C
[ATTENTION]
Please do not tighten the (D) screw too strongly when you
install the back cabinet again. The screw comes not to be
tightened.
MAIN BOARD REMOVAL
Remove 7 screws (C:3x6) to take the main board off.
POWER UNIT REMOVAL
Remove 6 screws (C:3x6) to take the power unit off.