Sanyo DP46841 - Mechanical Disassembly Procedures; Stand Base and Back Cabinet Removal

/
/9'6&DEOH
32:(581,7
$
67$1'%$6(
$
$
$
&
'
%
'
'
'
(
(
&
&
& &
&
&
&
&
&
&
&&
&
– 6 –
BACK CABINET REMOVAL
1. Remove 20 screws (B:3x6, 1 pc.; C:3x10, 13 pcs.;
D:4x8, 4 pcs.; E:3x10, 2 pcs.)
2. Detach AC cord from cabinet back.
3. Take off the cabinet back.
CAUTION:
This LCD TV uses several different kinds of screws. Using the correct screw is necessary to prevent damage.
Lead wires must be redressed to their previous locations after servicing. The Earth sheet and gasket are
provided to prevent interference to other radio and television receivers. The Earth sheet and gasket should
be returned to its previous position after servicing.
STAND BASE REMOVAL
Position TV face down on a padded or cushioned
surface to protect the screen and finish.
Remove 4 screws (A:M6X12) and remove the
stand base from the TV.
MECHANICAL DISASSEMBLY