English 7
3 RECORDING
Use the following procedure to record the monitored video
in the normal recording area.
1 Press the [REC/STOP] button.
The REC/STOP indicator lights up, “REC” appears on-
screen (i.e., the recording symbol), and recording starts.
z When recording for the first time, the default settings
are used. For details regarding modification of the
picture quality or recording rate, see INSTRUCTION
MANUAL.
z When the space remaining in the normal recording area
drops below a preset value, recording will stop, and the
FULL indicator will remain lit. Modification of the
<RECORD SET> allows recording to start again from
the beginning. (See INSTRUCTION MANUAL.)
2 Press and hold the [REC/STOP] button
for approximately 3 seconds.
“REC” disappears from the operation display and
recording ends.
z Be sure to set the time before recording. The digital
video recorder needs setting the time for recording.
Use the following procedure to record the monitored video
for a preset length of time in the normal recording area.
1 Press the [TIMER] button.
The TIMER indicator lights up and the digital video
recorder enters timer recording standby mode.
(1) See INSTRUCTION MANUAL for more details on
timer recording settings.
(2) At the time specified for the start of timer recording, the
REC/STOP indicator lights up, “REC” appears on-
screen (i.e., the recording symbol), and recording starts.
(3) At the time specified for the end of timer recording, the
TIMER and REC/STOP indicators turn off, and
recording ends.
z When the space remaining in the normal recording area
drops below a preset value, recording will stop, and the
FULL indicator will remain lit. Modification of the
<RECORD SET> allows recording to start again from
the beginning. (See INSTRUCTION MANUAL.)
z Playback is possible even while recording. See
INSTRUCTION MANUAL for more details.
z If timer recording is not set, the button operation is not
adopted and a buzzer is sounded.
2 Press the [TIMER] button.
The TIMER indicator turns off and recording ends.
[REC/STOP] button [TIMER] button
POWER indicator [EXIT] button
Normal recording
Ending normal recording
02
0
01-01-04 00:00:00 REC REPEAT EN A ALARM 0000
Recording symbol
REC/STOP
REC/STOP
Timer recording
Stopping timer recording before completion
02
0
01-01-04 00:00:00 REC REPEAT EN A ALARM 0000
TIMER
TIMER
e00_l8hbe_us_qg_7.book Page 7 Tuesday, April 13, 2004 1:04 PM
To Next Page
Loading...
