Sanyo DSR-3706PA - To Stop Recording; Recording Video

Recording Video
3
English
■ To start recording:
Press the REC/STOP button while monitoring a
camera.
a The recorder starts recording the video from the current
camera.
■ To stop recording:
Press and hold the REC/STOP button for about
three seconds.
■ To use other recording types:
In addition to normal recording (which uses the normal recording
area), the following recording types are available:
¡Timer-controlled recording (using the normal recording area)
You can schedule a recording to occur at your specified times.
☞
See page 51 of the Instruction Manual.
¡Alarm recording (using the alarm recording area)
The recorder automatically starts recording in response to an alarm
input from an externally installed alarm switch or a motion sensor.
☞
See page 55 of the Instruction Manual.
¡Pre-alarm recording (using the alarm recording area)
The recorder also records the image and sound for the period
immediately before an alarm input to assist in analyzing the alarm
condition.
☞
See page 57 of the Instruction Manual.
2
0
02
26-10-06 09:30:00 REC REPEAT EN A
Indicates that recording is in progress.
1
■ About the internal hard disk:
The internal hard disk has a set of preconfigured settings for the
recording area allocations and recording modes, etc. These settings
can be adjusted to your desired purpose.
¡Recording area settings
☞
See page 43 of the Instruction Manual.
¡Recording mode settings (recordable duration indicator)
☞
See page 49 of the Instruction Manual.
¡Overwrite settings
☞
See page 46 of the Instruction Manual.
<RECORDING CONDITIONS SET>
NORMAL RECORDING AREA
OVERWRITE : ON
ALARM RECORDING AREA
OVERWRITE : ON
REMAINING DISK WARNING : **
SERIES RECORDING : OFF
AUTO DELETE : OFF
<NORMAL REC MODE SET>
PICTURE QUALITY : ENHANCED
AUDIO RECORDING : OFF
REC RATE : 12.5FPS ( 61H)
REC PROGRAM GROUP : OFF
Recordable
duration
<RECORDING AREA SET>
TOTAL CAPACITY : 120GB
NORMAL RECORDING AREA : 80 %
AREA FULL RESET ->
ALARM RECORDING AREA : 19 %
AREA FULL RESET ->
ARCHIVE AREA : 1 %
AREA FULL RESET ->
CAUTION : WHEN THE AREA SETTING IS CHANGED,
THE WHOLE AREA WILL BE INITIALIZED !
1%
80%
1%
80%
Alarm
recording
area
Archive area
Normal recording
area
19%19%
1, 2