Preferences
You can set the unit to reduce the power consumption or adjust the
backlight brightness in Location setting.
fun-Link (HDMI CEC) allows you to operate your connected HDMI-CEC
device.
Setting your location to home
Choosing Home gives you full flexibility to change predefined settings
for picture and sound.
1
Use H I to select Preferences, then press OK.
2
Use H I to select Location, then press OK.
TV placement
Location
HDMI mode
Home
Retail
Restore default settings
Preferences
Language
Retail Demo
fun-Link (HDMI CEC)
3
Use H I to select Home, then press OK.
Retail
The unit will be set up with predefined settings for
retail displays. In this setting, you can set the
backlight brighter.
Home
The unit is set to maximize the energy efficiency for
home setting and it can be adjusted through a choice
of picture and sound quality selections according to
your preference.
Note(s)
●
You must set Home in the menu. Otherwise, personalized picture and sound settings will
not be memorized after the unit goes into standby mode.
HDMI mode
If there are issues with picture/color and/or sound when connecting an
external device using the HDMI port, please try switching the HDMI
mode following the instructions below.
1
Press Z and use J K to select Setup, then press OK.
2
Use H I J K to select TV settings, then press OK.
3
Use H I to select Installation, then press OK.
4
Use H I to select Preferences, then press OK.
5
Use H I to select HDMI mode, then press OK.
6
Use H I to select HDMI1, HDMI2 or HDMI3, then press OK.
7
Use H I to select Max 4K@60Hz + HDR, Max 4K@60Hz or Max
4K@30Hz (Compatibility) depending on the output capabilities of
the external device, then press OK.
●
When switching the HDMI configuration, the screen will black out
for a moment, then come back on.
Note(s)
●
The HDMI connector with HDMI mode set to Max 4K@30Hz (Compatibility) supports up
to UHD 30P, while The HDMI connector with HDMI mode set to Max 4K@60Hz supports
up to UHD 60P. The HDMI connector with HDMI mode set to Max 4K@60Hz + HDR
supports up to UHD 60P with HDR signal.
●
Switching the HDMI mode may cause loss of HDMI CEC functionality in certain cases.
TV placement
To apply the best settings for your TV, select wall mount or stand
mount.
1
Use H I to select Preferences, then press OK.
2
Use H I to select TV placement, then press OK.
3
Use H I to select Wall mounted or On a TV stand, then press
OK.
Retail Demo
When you set Location to Retail, E-sticker (Electronic Sticker) is
displayed. E-sticker can be turned off using procedure below.
1
Use H I to select Preferences, then press OK.
2
Use H I to select Retail Demo, then press OK.
3
Use H I to select Off, then press OK.
32 .English
Continued on next page.
To Next Page
Loading...
