Sanyo FWSB415E - Choosing Preset Sound; Night Mode

–
14
–
EN
Choosing preset sound
1
Press either , , , or on the remote control to select the desired
preset sound suitable for the audio that is playing.
2
The 2 LEDs (LINE and PAIR) blink once.
Sound mode LED lighting patterns
STANDARD
SPORTS
MUSIC
MOVIE
NEWS
LINE USB
INPUT
AUX PAIR
OPTICAL
3
When the preset sound setting is set, LED indicators go back to the current input.
NOTE(S)
• Select any preset sound according to your preference, regardless of categories.
• The default preset sound is MOVIE.
• This setting will remain while the soundbar is in standby mode.
Night mode
Night mode 1
Turns down the volume on the subwoofer. It is useful late at night.
1
To switch the unit to night mode 1, press .
Night mode 2* (dynamic range control)
Adjusts for clarity even when the volume is low, by compressing the range of the lowest sound level and the highest
sound level.
1
To switch the unit to night mode 2, press and hold .
* This function is only effective for Dolby Digital sounds.
* This function is only available when the soundbar is connected via optical.
Mode LED lighting patterns LED behavior Sound effects
Night mode 1
LINE USB
INPUT
AUX PAIR
OPTICAL
On: Flashes 4 times
Off: Flashes twice
On: Lowers the volume of the subwoofer.
Off: Outputs the sound at the same volume
as the original.
Night mode 2
LINE USB
INPUT
AUX PAIR
OPTICAL
On: Flashes 4 times
Off: Flashes twice
On: Turns down loud sounds and turns up
soft sounds in order to keep voices at a
comfortable volume.
Off: Outputs the sound at the same volume
as the original.
Input source Night mode 1 Night mode 2
OPTICAL Dolby Digital
4 4
PCM
4
-
LINE
4
-
AUX
4
-
USB
4
-
BLUETOOTH
4
-
NOTE(S)
• The default setting of both night modes are off.
• These settings will remain while the soundbar is in standby mode, so again use
to turn the mode from current
mode to the next mode.