Sanyo HEC-DR7700 - Massaging (Automatic Course) (Continued); Adjust the strength of massage.

- 20 -
HEC-DR7700
Replacement Procedure
(7) Replacement of Remote Control
1, Take off the cover (arm rest lower) right.
Photo-2
2, Take off the power supply box assembly.
Photo-10
3, Remove each connector processing and
disconnect the connectors. Photo-12
4, Remove nine remote control case set screws
and take off a remote control case (lower).
Photo-13
5, Remove two PCB (remote control) set screws
and take off the PCB (remote control).
Photo-14
6, Disconnect the interconnecting connector
CN1 of the connector (remote control A).
Photo-14
(8) Replacement of Sensor
1, Take off the cover (arm rest lower) right.
Photo-2
2, Take off the power supply box assembly.
Photo-10
3, Remove each cord processing and
disconnect the cords. Photo-12
4, Remove four sensor case set screws and
take off the sensor case (upper).
Photo-15
5, Take off the PCB (sensor). Photo-16
6, Disconnect the interconnecting connector
CN701 ,CN702,CN703 of the connector
(sensor A). Photo-16
PCB (remote control)
CN1
Remote control case set screws
Remote control case (lower)
Photo-13
Photo-12
PCB set screws
Connector (remote control A)
Photo-14
Sensor case set screws
Sensor case (upper)
Photo-15
Photo-16
Connector (remote control B)
Connector joint
Connector ( sensor A)
Connector ( sensor B)
Connector (sensor A)
Connector (sensor A)
PCB (sensor)
CN703
CN701
CN702