Sanyo HEC-RX1 - Motor Operation Confirmation Procedure; Start-up of Examination Mode; Air-Bag Operation Confirmation; Motor Operation Confirmation

- 7 -
HEC-FX1/RX1
Motor Operation Confirmation Procedure
PROGRAM "STRETCH" button
<Seat under><Control>
Reclining motor
(Back rest)
Reclining motor
(Foot rest)
Turn ON the POWER switch at the rear of the main body while simultaneously pressing the
RECLINING "DOWN" and LEG "DOWN" buttons on the control.
(This operation should be started with the POWER switch turned OFF).
When the examination mode is started up, both a back rest and a foot rest move slightly and
come to a stop.
1, Start-up of Examination Mode
Press the "ON/OFF" button on the control.
Press the PROGRAM "STRETCH" button on the control.
Reclinning motor (foot rest/back rest) repeat the expansion and contraction.
Whenever the PROGRAM "STRETCH" button is pushed, the operation starts and stops
alternately.
* After you exchanged the reclining motor or PCB, confirm the movement by this function.
When there is an abnormality, find out the problem and repair.
As for this function, the air pump and the valve also move at the same time.
To remove the examination mode, turn OFF the POWER switch.
2, Air-Bag Operation Confirmation
3, Motor Operation Confirmation