12
Need help?
Visit our Web site at www.sanyoctv.com or Call 1-800-877-5032
USING THE REMOTE CONTROL
PRECAUTIONS
To ensure safe operation, please observe the following precautions:
Replace both batteries at the same time. Do not use a new battery with
a used battery.
Risk of explosion, if battery is replaced by an incorrect type.
Do not expose the Remote Control Unit to moisture or heat.
12
13
14
11
16
15
17
18
Point toward
DTV
REMOTE CONTROL KEYS
Input Key—Press to change the input signal source
as follows: Analog RF Digital RF Video1 Video2
Video3 HDMI Analog RF.
Number Keys—Two keys must be pressed to select
a direct channel. Example: Press 0 then 6 to select
channel 6.
For Analog Cable channels above 100, press and
hold the 1 key until C1– – appears, then press the
other two numbers.
Info Key—Press to display the Digital and Analog Full
Banner information (press again to remove the
display).
Digital Full Banner display—Contains a two-part
Channel Number (Major and Minor) and Tuner ID. If
available the following is also included: Station ID,
Program Title, V-Chip Program Rating, Audio Info, and
Signal Strength.
Analog Full Banner display—Contains the Channel
Number (analog antenna/cable), Tuner ID, Station ID (if
available), Program Title (if available), V-Chip Program
Rating, and Audio Info.
Program Rating
Signal Strength
Audio Info
Program Rating
Channel No.
Station ID
Channel
Major Minor
Audio Info
Tuner ID
Tuner ID
Program Title
Program Title
Station ID
To Next Page
Loading...
