Sanyo HTD-5201 - ADDITIONAL CONNECTIONS EXAMPLES; Connecting to a TV with an S-video lead; Connecting to a TV with a EURO-AV cable; Connecting to a digital multi-channel AV amplifier

- 5 -
MECHANISM OPERATION
1.How to setting the TRAY
1. Move the SLIDE left side.
2. Match the Hole of GEAR
5 and Hole of CHASSIS 4.
CHASSIS
FRONT SIDE
MOTOR
MARKER
MARKER
1
2
2
3
3
3. Match the mark of GEAR 2 and mark of GEAR 3, and then
install the BOSS.
4. Turn the GEAR
1 counterclockwise, and then SLIDE move
right side.
5. The GEAR
1 move from side to side.
RIB
RIB
GREASE
EM-50L
GREASE
EM-50L
GREASE
EM-50L
LARGE TOOTH
GEAR HOLE
CHASSIS HOLE
5
4
6. Match the hole of GEAR 7 and hole of chassis while turning
GEAR 6.
7. Match the mark of LOADING GEAR
8 and gear of TRAY
where see horn hole 9 of tray.
8. Push a TRAY with the state that turned the entire surface of a
TRAY into approximately 5 degrees the lower part slowly.
LOARDING
GEAR
MARKER
MARKER
TRAY
HOLE
6
7
8
9