Operation
with the
Remote
Control
Unit
TEM@
C)N4/OfFO
STEP
3
COOLER
STEP
4
FAN
COOL
TIMER
NORM PROGRAM
CLOCK
OFF 0M
CZZZD
agijij—
PROGRAM
TIMER
LOW HIGH
NIGHT SETBACK
MED AUTO
STEP 5
FAN
SPEED
NOTE:
1. Cooling
NOTE:
CAUTION:
01-352-09
Check that
the circuit breaker
on the power panel is turned on
and the
operation selector of
the indoor unit
is in the ON position.
STEP 1:
STEP 2:
STEP 3:
STEP 4:
STEP5:
Set the MODE selector switch to COOL
Set the timer selector switch to NORM.
Press the ON/OFF
operation button.
Press the COOLER or WARMER
button to set a cooler or
warmer temperature.
Each time you press these buttons, the set temperature
varies by 2 0 F.
840 F max.
640
F
min.
Set the fan speed selector switch to the setting you want.
To stop the air conditioner,
press the ON/OFF operaion button again.
Choose
the best position in the room for the remote
control
unit,
which also
acts
as the sensor
for room comfort and
transmits
the operating instructions.
Once you've found this
best
position, always keep the remote
control unit there.
This
appliance has a built-in 3-minute time
delay circuit to ensure
reliable
operation.
If the operation button
is pressed, the compressor
will
start
running
after three minutes. In
the event of power
failure,
the
unit
will
stop. When the power is
applied, the unit will re-start
automatically
after
3 minutes.
To
prevent
the
appliance
from malfunctioning, do not set any
selector
switch
between
two indicated
positions. Make sure
that
it
clicks
into
position.
9
To Next Page
Loading...
Need help?
General
