Sanyo M GP9 - Disassembly Instructions; Tape Mechanism Adjustments; Tape Mechanism Standards

DISASSEMBLY INSTRUCTIONS
ADJUSTMENTS
STANDARDS OF THE TAPE MECHANISM
All necessary adjustments to maintain the sufficient ability on the tape section should be made in accordance with
the following specifications.
item
STE
Detail
Specification
Responsive
component
Auto stop
The
PRESSURE
of
the
tape
tight
sensor
(3).
0.88
~
1.23
ozs.
(25
~
35
grams)
Coil
spring
(16)
Pinch roller
Head azimuth
Motor speed
—++.__
The PRESSURE of the Pinch roiler (18).
2.8 ozs. (more than 80 grams) Coil spring (6)
“The obtainable output voltage,’’ when the unit For the maximum output. Screw (23)
play back the test tape (6.3 kHz, Azimuth tape).
“The
output
signal
frequency,’’
when
the
unit
3
kHz
SVR601
in
the
Battery
play
back
the
test
tape
(3
kHz).
compartment.
Torque
+——
Take
up
torque
of
the
Tape
winder
PLAY
0.4
—
0.83
ozs.
inch
(30
—
60
g.cm)
F.FWD 0.4 — 0.83 ozs. inch (30 — 60 g.cm)
Note:
If
any
fails
to
meet
the
above
specification,
then
clean
the
Drive
beit,
Flywheel,
Motor
pulley,
Take
up
reel,
and
the
related
parts
with
a cotton
swab
soaked
with
alchole.
SANYO CANADA INC.
Feb./’86/2700 NS Printed in Japan