Sanyo MCO-19MUVH - Basic Operations on Control Panel

24
BASIC OPERATIONS ON CONTROL PANEL

The following operation are possible through control panel:

z Setting the temperature・・・The chamber temperature can be set (page 25).
z Setting the CO
2
density・・・The chamber CO
2
density can be set (page 25).
z Setting the O
2
density・・・The chamber O
2
density can be set (page 25).
z
Setting the key lock・・・Changing the temperature and CO
2
density can be disabled (page 26).
z Setting alarms・・・The temperature alarm, CO
2
density alarm, O
2
density alarm (page 33) and upper
limit alarm temperature (page 32) can be set.
z Setting UV parameters・・・ON/OFF parameters and the ON period of the UV lamp can be set for the
MCO-19M(UVH)/19M(UV) or when the Incubator is equipped with the optional MCO-19UVS (page 36).
z Setting other parameters・・・The initial settings of the date, time, and log cycle (page 38), and the
LCD display and baud rate (page 40) can be set.
z Displaying the operation log and transferring data・・・A graph of past operation data can be
displayed (page 41) and operation data can be transferred to a PC (page 43).
z H
2
O
2
decontamination・・・H
2
O
2
decontamination of the chamber and internal attachments can be
performed when the optional H
2
O
2
Generator (MCO-HP) is installed (page 49).
z Automatic N
2
(or O
2
) gas cylinder changeover・・・The N
2
(or O
2
) gas cylinder can be switched (page
30). The CO
2
gas cylinder can be switched when the optional automatic CO
2
Cylinder Changeover
System (MCO-21GC) is installed (page 67).
z Setting the standard gas density・・・The standard gas density can be set when the optional
Automatic Standard Gas Calibration Kit (MCO-SG) is installed. (page 69)

Get other manuals https://www.bkmanuals.com