Need help?Do you have a question about the Sanyo MDF-192AT and is the answer not in the manual?
Defines hazard levels, explains symbols, and details unit label significance.
Advises on safe installation locations and proper electrical connections to prevent hazards.
Covers operational safety, health risks, repair warnings, and proper unit disposal procedures.
Offers advice on power sources, cleaning, cooling pipes, temperature variations, inner lids, and access ports.
Provides operational notes on surface heat, filter status, alarm system behavior, and control panel protection.
Specifies the required environmental conditions for safe and optimal equipment operation.
Identifies the external parts of the freezer as shown in the diagram.
Provides detailed descriptions for each numbered component of the freezer unit.
Details the layout and operational functions of the freezer's control panel.
Specifies ideal conditions for the installation site to ensure proper operation and safety.
Outlines the step-by-step procedure for installing the freezer unit, including grounding.
Guides through the initial start-up process and describes operation following power failures.
Details the procedure for setting the desired temperature within the freezer compartment.
Explains how to configure the high temperature alarm settings for the unit.
Describes the process for setting the duration before an alarm condition reactivates the buzzer.
Details the remote alarm terminal, its output, and capacity for external monitoring.
Summarizes the unit's alarm functions, their triggers, indications, and safety operations.
Provides instructions for managing the temperature recorder's chart paper and replacing its dry cell.
Covers setting back-up temperatures and penholder installation for the temperature recorder.
Details the monthly cleaning process for the freezer's exterior and interior.
Explains how to remove frost from the freezer compartment to maintain performance.
Guides on cleaning the condenser filter to prevent cooling issues and compressor strain.
Addresses refrigeration failures, poor cooling, and noise troubleshooting.
Troubleshoots issues with the alarm test key, temperature recorder, and back-up system.
Provides safety warnings regarding unit storage and emphasizes professional disposal methods.
Details battery location, removal process, and safe handling procedures.
To Next Page
General
