Sanyo MDF-U76V

42 pages

To Next Page

To Next Page

Loading...

MDF-U76V

Ultra-Low Temperature Freezer

INSTRUCTION MANUAL

Table of Contents

Questions and Answers:

J
Jason JonesAug 5, 2025
Why is my Sanyo MDF-U76V cooling poorly?
- E
  Eduardo HallAug 5, 2025
  If your Sanyo Freezer is not cooling well, several factors could be the cause. Ensure that the ambient temperature is not too high, the inner door latch is completely closed, and the outer door is firmly shut, checking for any frost or ice preventing a proper seal. Verify that the air intake vent is not blocked and the condenser filter is clean. Also, confirm that the temperature is set correctly, the freezer isn't in direct sunlight or near a heat source, the rubber cap and insulation are correctly placed on the access port, and you haven't put too many unfrozen items inside.
K
Katherine GomezAug 19, 2025
What to do if my Sanyo MDF-U76V is not cooling at all?
- C
  Christy KimSep 12, 2025
  If your Sanyo Freezer chamber isn't cooling at all, check if the circuit breaker of the power source is active, the voltage is adequate (if not, call an electrician), and the power is supplied. Also, ensure the breaker isn't free and that you haven't stored a large amount of items in the chamber at once.

Sanyo MDF-U76V Specifications

General

Brand	Sanyo
Model	MDF-U76V
Category	Freezer
Language	English

Summary

Introduction

Precautions for Safe Operation

Environmental Conditions

Freezer Components

Control Panel

Detailed explanation of the control panel functions, indicators, and buttons for operation.

Remote Alarm Terminal

Description of the remote alarm terminal and its contact output for external alerts.

Air Intake Port

Explanation of the air intake port, its function, and maintenance procedures.

Installation Site

Installation

Start-Up of Unit

Chamber Temperature Setting

Key Lock Function

Alarm Temperature Setting

Setting of Alarm Resume Time

Monitor of Freezer Status

Change of Compressor Delay Time

Change of Door Alarm Delay Time

Alarms & Safety Functions

Routine Maintenance

Cleaning of Cabinet

Instructions for cleaning the interior and exterior of the freezer unit.

Cleaning of Condenser Filter

Procedure for cleaning the condenser filter to maintain performance and prevent issues.

Defrosting of Inside Wall

Cleaning of Air Intake Port

Trouble Shooting

Disposal of Unit

Recycle of Battery

Information on recycling the unit's rechargeable battery and proper disposal methods.

Decontamination of Unit

Instructions for decontaminating the unit before disposal, especially if hazardous materials were stored.

Disposal of Battery

Temperature Recorder (Option)

Setting of MTR-G85

Step-by-step guide for setting up and loading the MTR-G85 temperature recorder.

Back-Up System (Option)

Independent Inner Door (Option)

Interface Board (Option)

Inventory Rack (Option)

Specifications

Performance

Safety Check Sheet

Related product manuals

Preview: Sanyo MDF-U730

Preview: Sanyo MDF-U72V

Preview: Sanyo MDF-U73VC

Sanyo MDF-U73VC

Sanyo MDF-U72VC

Preview: Sanyo MDF-U7386S

Sanyo MDF-U7386S

Sanyo MDF-U7386SC

Preview: Sanyo MDF-U55V

Preview: Sanyo MDF-U53VA

Sanyo MDF-U53VA

Sanyo MDF-U54VC

Preview: Sanyo MDF-U500VX

Sanyo MDF-U500VX