8.
About Various Modes
Models MLS-3751 U3781 L are equipped with the following modes. As for the detail, refer to the pages
of
respective modes.
Setting mode: Display
of
processing frequency,
history
of
errors, etc. and settings. etc.
Test mode:
Display
of
temperature and pressure in the chamber, adjustment
of
thermistors,
pressure sensors, etc.
Demonstration mode:
Display
of
actual operation status and demonstration
of
operation, etc.
-How
to enter into the setting mode
1.
Tum
ON
the power switch.
2.
When the
".A.
"+
"SET/CONFIRM" buttons are pressed for
about
2 sec. while pressing the "START" button, "Short Beep
x
3"
sound is heard and at the same time the decimal point
on
the Digital Display I flickers. (See the right figure.)
3.
After the status has become such as
in
2, when the "START"
button is pressed within 5 sec. while pressing the
".A."+
"T"
buttons, "Beep· sound is heard, and at the same time the
mode becomes the setting mode and
model name and speech
language are displayed.
-How
to cancel the setting mode
flicker
"c
sterilization
1-
1
When the power switch
is
turned
OFF,
the setting mode
is
cancelled.
Or,
when the "STOP" button
is
pressed to enter into the test mode and the operation
in
the "How to cancel the test mode·
is
performed,
the setting mode reset to the
normal mode.
-How
to enter into the test mode
A.
In
stand-by display
Enter into the setting mode according to the procedure
in
the
"How to enter into the setting mode" and press the "STOP"
button. Then, "Beep" sound
is
heard and at the same the
mode changes to the test mode. The difference from the
normal mode is such that the decimal point
on
the Digital
Display I lights up. (See the right figure.)
B.
In
operation
When the procedure
in
the "How to enter into the setting
mode" is performed during operation, "Beep· sound
is
heard
and at the same time the mode changes to the test mode.
-How
to cancel the test mode
Flicker
Light-up
Sterilization
I
51e
.lizati~
12
1
0:2'1
"c
Time
When the power switch
is
turned
OFF,
the test mode
is
cancelled.
Or,
when the "START" button is pressed
for about 2 sac.
while pressing the
".A."+
"SET/CONFIRM" buttons, "Short Beep
X3"
sound
is
heard and
at the same time the test mode returns to the normal mode.
-How
to enter into the demonstration mode
1.
Turn
ON
the power switch.
2.
Start the reservation operation.
3.
When the "Cycle selection" + "STOP" buttons is pressed within 5 sec. after starting the reservation
operation, "Beep Beep Beep· sound
is
heard and at the same time the stand-by
is
displayed and the
mode changes to the demonstration mode.
-How
to cancel the demonstration mode
When the power switch
is
tumed
OFF,
the demonstration mode is cancelled.
-
22-
To Next Page
Loading...
