Sanyo MLS-3781L - Page 32

Select the instrument sterilization
cycle and set the sterilization
temperature at 135'C and the
sterilization time at 30 min. Close
the cover and press the STRAT
~.
Set the cycle, sterilization temp.
and time.
OC and sterilization process
Reaching 135
Press the
"V"or ",6." button
while pressing the
SET lCONFIRM button and
adjust the pressure so that the
pressure
display becomes same
as the value on the pressure
gauge
of the product.
When the START button is
pressed While pressing the
SET /DISPLA Y button I the
corrected
value is written in.
Pressure adjustment
(Correction)
(See the Mght figure.)
The pressure gauge of the
product shows the pressure in
MPa and the pressure display
value
in kPa.
Pressure adjustment
(WMting-in)
-31-
Nonmal display
Release. SET/COFIRM Press
Example of pressure
correction
display
button
Pressure Corrected
display value value