B
Brianna RamirezJul 28, 2025
What to do if my Sanyo PDG-DWL2500 Projector lamp has been used overtime?
- EElizabeth WardJul 29, 2025
If the lamp has been used overtime, replace the lamp immediately and then reset the lamp counter.
What to do if my Sanyo PDG-DWL2500 Projector lamp has been used overtime?
If the lamp has been used overtime, replace the lamp immediately and then reset the lamp counter.
What to do if my Sanyo PDG-DWL2500 detects an abnormal condition and cannot be turned on?
If the projector detects an abnormal condition and cannot be turned on, unplug the AC power cord and plug it in again to turn on the projector. If the projector turns off again, unplug the AC power cord and contact the dealer or the service center for service and checkup.
Why my Sanyo PDG-DWL2500 Projector cannot be turned on until cooling is completed?
The projector cannot be turned on until cooling is completed because it is preparing for stand-by, or the projection lamp is being cooled down. Wait until cooling is completed and the POWER indicator stops blinking.
What to do if Sanyo Projector is in stand-by mode?
If the projector is in stand-by mode, press the ON/STAND-BY button to turn on the projector.
Why is there no sound coming from my Sanyo PDG-DWL2500 Projector?
If there's no sound from your Sanyo Projector, try these steps: First, check the audio cable connection from the audio input source. Then, adjust the audio source volume. Also, press the Volume + button and ensure the Mute button is not activated. Note that when the AUDIO OUT is plugged-in, the projector's built-in speaker is disabled. Finally, sound is only available when an image is projected, so ensure an image is displayed.
What to do if the exclamation mark appears on the screen of Sanyo PDG-DWL2500 Projector?
If an exclamation mark appears on the screen of your Sanyo Projector, it indicates that your operation is invalid. Please review your actions and operate the projector correctly.
Why can't I select the terminal function on my Sanyo Projector?
The Terminal function on your Sanyo Projector cannot be selected after Computer 2 is selected. To enable the Terminal function, select another input source such as Computer 1, HDMI, S-video, or Video.
Matrix size | 0.65 \ |
---|---|
Projection distance | - m |
Vertical scan range | 50 - 120 Hz |
Horizontal scan range | 15 - 93 kHz |
Projection technology | DLP |
Contrast ratio (typical) | 2000:1 |
Screen size compatibility | 60 - 110 \ |
Projector native resolution | WXGA (1280x800) |
Focus | Manual |
Digital zoom | 16 x |
Focal length range | - mm |
Aspect ratio | 16:9 |
RS-232 ports | 1 |
Dimensions (WxDxH) | 320 x 175 x 386 mm |
Power requirements | 100 - 240 V |
Lamp power | 275 W |
Light source type | Lamp |
Service life of light source | - h |
Service life of light source (economic mode) | 3000 h |
Noise level | 28 dB |
Dot clock scanning frequency | 150 MHz |
RMS rated power | 10 W |
DVI port | No |
Serial interface type | RS-232 |
USB 2.0 ports quantity | 0 |
Power consumption (standby) | - W |
Power consumption (typical) | 400 W |
Weight | 6215 g |
---|