Sanyo RM-6090 - USING THE SLEEP TIMER; USING THE SLEEP TIMER AND WAKE-UP TIMER

USING THE SLEEP TIMER
1. Set the FUNCTION switch to OFF, ALARM-RADIO or ALARM-BUZZER.
2. Push the SLEEP button.
“0:59” (59 minutes) appears. The radio turns on and will turn off automatically after 59
minutes.
- To select the desired time, while holding the SLEEP button down, push the FAST
UP or SLOW UP button to select the sleep time. Release the SLEEP button.
NOTES:
- To release the sleep time while in operation, set the FUNCTION switch to ON then
OFF.
- If you push the SLEEP button after sleep time setting, the sleep time will be shown.
(If you hold the SLEEP button more than about 2 seconds, it will count down
automatically.)
USING THE SLEEP TIMER AND WAKE-UP TIMER
1. Set the wake-up time and select ALARM-RADIO or ALARM-BUZZER.
(See “WAKE-UP TIME SETTING” and “USING THE WAKE-UP TIMER”.)
2. Set the sleep time. (See “USING THE SLEEP TIMER”.)
3. Tune in a station and adjust the volume level as desired.
7
RM-6090/AU 10/05/2003, 9:498