6
F4
F3
F7
F6
F5
LISTENING TO YOUR RADIO
Hints for better reception
This radio carries a single DAB/FM lead wire antenna, to obtain the best performance, you should fully
extend the wire antenna and adjust the position as well as the direction until you find the best
reception. For ideal DAB reception, always maintain the lead wire antenna in a vertical position
(holding it upward or downward behind the unit) is highly recommended.
DAB mode
If the radio is connected to the power and then switched on from standby for the first time, the radio will
automatically enter into the DAB mode and perform auto scan function. During the scan the display
will show “Scanning …” together with a slide bar that indicates the progress of the scan and the
amount of stations that have been found so far. (F. 3) (F. 4)
Once the scan has finished, the radio will select the first alphanumerically found station. To explore
the fou nd sta ti on s, first press the JOG MODE/SELECT button once, then rotate the
VOLUME/SCROLL control. When you find a station that you would like to listen, press the SELECT
button.
Note: If there is no stations found after auto scan, the radio will then enter into the Tune Select Menu,
you can now rotate the VOLUME/SCROLL control followed by pressing the SELECT button to select
Manual tune or Auto scan modes for stations.
Auto scan modes
There are two types of auto scan modes, one is local auto scan and the other is full auto scan. Local
auto scan will only search for part of the DAB Band III channels and full auto scan will search for the
entire DAB Band III channels. After the scan has finished, the first alphanumerically found station will
be automatically selected.
1. To activate the auto scan modes, first press the MENU button to enter into the Tune Select Menu,
then rotate the VOLUME/SCROLL control to select “Autoscan local” or “Autoscan full”, finally
press the SELECT button to confirm, the display will show “Scanning …” and a progressing slide
bar. (F. 5)(F. 6)
2. All the stations that have been found will be stored automatically, to explore and select listening
to the found stations, first press the JOG MODE/SELECT button once, then rotate the
VOLUME/SCROLL control followed by pressing the SELECT button.
Manual tune
1. To select manual tune, first press the MENU button to enter into the Tune Select Menu, then
press the SELECT button to select “Manual tune”. (F. 7)
2. Rotate the VOLUME/SCROLL control to move through the DAB channels, the display will show
“5A to 13F” and their associated frequencies.(F. 8)
3. When your desired frequency appears in the display, press the SELECT button to confirm. The
name of the station group (ensemble/multiplex) will be displayed.
4. To listen to the station selected, press the SELECT button again.
F8
To Next Page
Loading...
