Care and Cleaning (continued)
Anti-Mold Filter The anti-mold filter behind the air intake grille should be checked and cleaned
at least once every two weeks.
How to remove the 1. Grasp both ends of
anti-mold filter the air intake grille
and pull it out and up.
2. Push the anti-mold
filter up slightly, and
then pull it down.
Cleaning Use a vacuum cleaner to remove light dust. If there is sticky dust on the filter,
wash the filter in lukewarm, soapy water, rinse it in clean water, and dry it.
How to replace the 1. With the ‘‘FRONT’’ mark
anti-mold filter facing you, slide the anti-mold
filter up into the unit and then
lower the handle into the
groove on the unit.
2. After installing the anti-mold
filter, press the locations
marked by the arrows ( )
and close the air intake grille.
OI-378-21EG
21
Air intake grille
Anti-mold filter
Air intake grille
Insert into the groove on the unit.
Anti-mold
filter
SAP-K121GJA-oi 3/4/00 16:50pm Page 21
Все каталоги и инструкции здесь: http://splitoff.ru/tehn-doc.html
To Next Page
Loading...
Need help?
General
