Sanyo SGP-E70J2GU2 - Page 126

Construction
E - 39
●Operating output of the external pump for dispensing hot water (applicable to E190J2GU2W)
1 Operating output of the external pump for dispensing hot water
Output from the outdoor unit 6P terminal board, No. 1 and No. 2 (See Fig. 1)
Output condition: Non-voltage A contact point (When the external pump is operating “contact point closed”,
when stopped “contact point open.”)
Maximum contact point capacity:AC200V 3A(cosθ =0.4)
2
For electrical cable construction refer to Electrical cabling system diagram (Fig. 2) and the electrical circuit attached to
the outdoor unit.
$TQYP $TQYP
%QPVCEVRQKPVQWVRWVHQT
GZVGTPCNRWOR
(KIWTG
(KIWTG'NGEVTKECNYKTKPIU[UVGOFKCITCO
1WVFQQTWPKV
6$
2VGTOKPCNDQCTF
'ZVGTPCN
RWOR
'NGEVTQOCIPGVKE
EQPVCEVQT
2QYGTUQWTEGHQT
VJGGZVGTPCNRWOR
2QYGTUQWTEGHQT
VJGGNGEVTQOCIPGVKEEQPVCEVQT
4. Outdoor unit installation and construction