To Next PageTo Next PageHow to check power supply for Sanyo Air Conditioner?
To check the power supply for your Sanyo Air Conditioner: * Verify that the voltage is within the specified range (±10% of the rating). * Ensure that power is being supplied to the unit.
How to check power supply wiring on Sanyo Air Conditioner?
To check the power supply wiring on your Sanyo Air Conditioner, ensure the power supply wires are correctly connected between terminal No. 1 & 2 on the 3P terminal plates in the indoor unit and the outdoor unit.
How to check inter-unit wiring on Sanyo SPW-C253GH5 Air Conditioner?
To check the inter-unit wiring on your Sanyo Air Conditioner, verify that the inter-unit control wiring (DC low voltage) is correctly connected between the indoor unit and outdoor unit.
How to check power supply wiring for Sanyo Air Conditioner?
To ensure your Sanyo Air Conditioner is functioning correctly, verify that the power supply wires are properly connected between terminal numbers 1 and 2 on the 3P terminal plates located in both the indoor and outdoor units.
General| Brand | Sanyo |
|---|---|
| Model | SPW-C253GH5 |
| Category | Air Conditioner |
| Language | English |
Crucial instructions for safe and efficient installation and service.
Guidelines for moving units, installing in various environments, and handling refrigerant/wiring.
Identifies intended users and the manual's purpose for different experience levels.
Explains the manual's structure and provides steps for effective navigation and use.
Detailed technical data for each air conditioner model, including performance and ratings.
Specifications for major components, other parts, and refrigerant flow.
Physical dimensions of units and the operational temperature limits.
How the unit controls room temperature and fan speeds in cooling/heating.
Freeze prevention, overload protection, discharge temp. control, dehumidifying, defrosting.
Operation of 4-way valve, refrigerant control, compressor monitoring, and voltage detection.
Electric wiring diagrams and schematic for indoor units.
Electric wiring diagrams and schematics for outdoor units.
Guides for identifying and resolving unit malfunctions using flow charts and alarms.
Diagnosing component failures and using remote controller service features.
Procedures for insulation resistance, protective devices, and electrical parts testing.
PCB settings, address configuration, and conducting operational test runs.
