REMOVAL AND INSTALLATION
-
GENERAL REMARKS
● AI]
wiring should be returned to the original position after work is completed.
. Before adjusting the mechanism of this unit, wipe the tape contacting surfaces clean as well as the contacting
surfaces of the driving parts with a cotton swab or a soft cloth soaked in alcohol.
Trouble may occur because of oil and grease stains.
● Handle the belt carefully because grease easily attaches to it.
Then check the used rubber parts.
If the rubber has deteriorated or is scratched, replace the parts with new one.
a. TOP LID
b. AMP. P.C. BOARD &
MECHANISM
c. WIRING LAYOUT
.
Arrange the wiring as shown in the figure.
BLACK
RED
—1 l—
BLACK> BROWN
-2-
To Next Page
Loading...
