Opening the side cover and pressing the SET button for 2 seconds or more causes the menu screen to be
displayed on the monitor.
On the menu screen, all information is displayed in English.
Each setting can be configured via network operation on a configuration menu screen.
If you plan to operate the camera via the network, you need to configure the network information, such as the IP
address, on the camera.
You can skip this configuration if you choose to use the defaults.
<Default>
DHCP: OFF
IP ADDRESS: 192.168.000.002
SUBNET MASK: 255.255.255.000
GATEWAY: 192.168.000.001
PORT: 80
You can change the configured network settings via the network on the NETWORK SETTINGS
screen.
For the network configurations, contact your network administrator.
Introductio
To Next Page
Loading...
