1 Use the / button to select [NETWORK SET] on the menu screen, and press the SET
button.
The network configuration screen appears.
2 Select [DHCP] using the / button and press the SET button.
The symbol appears beside the available option, and you are ready to configure it.
3 Use the / button to select “ON” or “OFF” for [DHCP], and press the SET button.
The setting is saved and the symbol disappears.
OFF: Sets the IP address manually (Go to step 4 .)
ON: Enables automatic address configuration using DHCP. (Go to step 7 .)
Setting [DHCP] to “ON” causes the menu items [IP ADDRESS], [SUBNET MASK], and [GATEWAY]
to disappear.
4 Select [IP ADDRESS] using the / button and press the SET button.
The IP ADDRESS screen appears.
5 Move the cursor to the desired position using the / button, select a number in each
digit using the
/ button, and then press the SET button.
The configured address setting is saved and you return to the network configuration screen.
6 In the same way as you did in [IP ADDRESS] (step 4 to 5 ), configure the settings in
[SUBNET MASK] and [GATEWAY].
7 Select [PORT] using the / button and press the SET button.
The PORT screen appears.
When [SSL] is set to “ON” on the NETWORK SETTINGS screen, the screen title appears as [PORT
(SSL)].
8 Move the cursor to the desired position using the / button, select a number in each
digit using the
/ button, and then press the SET button.
The configured port number is saved and you return to the network configuration screen.
Introductio
To Next Page
Loading...
