You can store the zoom and focus settings of surveillance locations by camera setting number (either 1 or 2).
These stored zoom and focus settings can be retrieved by selecting [CAMERA] and choosing the camera setting
number.
Use the / button to select [POSITION] and use the / button to choose “ON”, and press
the SET button.
The [POSITION] screen appears, where the buttons function as the zoom buttons and the buttons
serve as focus buttons.
If you do not store zoom and focus settings, set [POSITION] to “OFF”.
Use the / button to adjust the zoom and use the / button to adjust the focus and press
the SET button.
This stores the zoom and focus settings and brings you back to the CAMERA setting screen.
1
2
The / button can be used to adjust the focus even when the auto focus is set ([FOCUS] is set to
“AUTO”).
When [POSITION] is set to “OFF”, the zoom and focus settings stored in the camera will be
overwritten by those settings of the current position.
In the same way, performing zoom or focus operation with [POSITION] set to “OFF” also overwrites
the zoom and focus settings stored following this procedure.
37 / 100
To Next Page
Loading...
