Sanyo VCC-XZ600P - Disabling Password Lock (PASSWORD LOCK)

Use the / button to select [PASSWORD LOCK], and press the SET button with “ON
↓
”
displayed.
The password entry screen appears.
Use the / button to select the digit and use the / button to select a number for the digit.
Repeat this procedure until the whole password value is entered, and press the SET button.
When the valid password is entered, “OK” appears. When a wrong password is entered, “NG” appears.
Press the SET button again.
This disables the password lock function, and the PASSWORD screen appears again.
When the password lock is disabled, “OFF” is displayed for [PASSWORD LOCK].
Select [MENU] and choose “BACK” or “END” to complete the setting.
1
2
3
4
62 / 100