Use the / button to select [STABILIZER], use the / button to choose “ON”, and press the
SET button.
The STABILIZER screen appears.
When you do not want to correct the sway of the camera, choose “OFF” for the [STABILIZER] setting.
Use the / button to select [LEVEL], and use the / button to choose the correction level.
Available settings: LOW, MIDDLE, HIGH
Select [MENU] and choose “BACK” or “END” to complete the setting.
1
2
The higher the correction level, the lower the image resolution during correction. The angle of view
will also be slightly narrower.
The correction function will not work in the following condition.
During switching images between color and black/white modes when using the Day/Night function
When the menu screen is displayed
Immediately after powering ON the camera (for about 1 minute)
Beside the conditions above, the correction function may not work depending on the sway level or
cycle.
3
70 / 100
To Next Page
Loading...
