Sanyo VCC-XZ600P - Page 71

Use the / button to select [SYSTEM], and press the SET button.
The SYSTEM screen appears.
Use the / button to select [CONTROL], and use the / button to select the communication
mode.
Available settings:
The [PROTOCOL] setting is fixed to “SANYO”.
Use the / button to select [ADDRESS], and press the button.
The ADDRESS setting screen appears.
Use the button to select the digit and use the / button to enter the number, and press
button. Repeat the procedure until the entire address is entered.
The SYSTEM screen appears again.
1
2
COAX (coaxial superimposed communication): Supports Sanyo’s coaxial SSP/fast SSP and PELCO-C
(auto-recognition).
485 (RS-485 communication): Supports Sanyo’s SSP/fast SSP (auto-recognition) and PELCO-D.
The VAC-70 control unit operates independent of the [PROTOCOL] setting.
1
2
71 / 100