Sanyo VM-EX25P - Loading and Unloading the Cassette

LOADING AND UNLOADING THE CASSETTE
A charged batterv pack must be installed on the To prevent accidental erasure of recorded material, use
camcorder for cassette loading and unloading. the erasure-prevention switch, as described below.
1 Press the EJECT button, the cassette holder will open. A: Recording is possible
2 Insert the cassette fully with the window facing B: Recording is not possible
outwards.
3
Gently
press
on
the
indication
“PUSH”
on
the
cassette
f
e-—-Z
TA
(A)
holder
until
it
clicks
into
place.
7
1
f
‘|
Before loading the cassette
Recorded cassettes or new cassettes tapes may be
loosely wound. Loose tape winding can be eliminated by
gently turning with a finger the left reel, see illustration, at
the bottom of the cassette.
Eo
i
Notes:
@ Do not cover the holes at the bottom of the cassette.
@ Store the cassettes in their case, away from strong
light or heat sources, standing upright (vertical) to
prevent dust from entering, as well as uneven tape
winding.
Unloading the cassette
1 Press the EJECT button, the cassette holder will open.
2 Remove the cassette.
3 Gently press on the indication “PUSH” on the cassette
holder until it clicks into place.
11