Sanyo VM-EX25P - Playback 6

PLAYBACK
The camcorder can be used to play back a recorded tape
and view it on a TV receiver.
For playback, a stable power supply to the camcorder is
necessary, it is recommended to use the AC adaptor/
charger. (See page 10.)
Load the recorded tape into the camcorder, then set the
POWER switch to “PLAYER”.
Using the PLAY, STILL, and STOP buttons
@ Press the PLAY button to start playback.
@ Press the STILL button for a still picture. Press the
STILL button again to resume playback.
@ Press the STOP button to stop playback.
Using the REW and FF buttons
@ Press the REW button to rewind the tape.
@ Press the FF to advance the tape.
To stop the tape, press the STOP button.
Special playback mode A
@ Press and hold the REW button while the tape is being
rewound to watch the reverse picture playback.
@ Press and hold the FF button while the tape is being
advanced to watch the picture playback.
@ Press the REW or FF button again to resume normal
tape rewind or advance.
Special playback mode B
@ Press and hold the REW button during playback to
watch the reverse picture playback.
@ Press and hold the FF button during playback to watch
the picture playback.
@ Press the REW or FF button again to resume normal
playback.
18
Using the SCENE SEARCH buttons
@ Press and hold the SCENE SEARCH (-) button during
still picture playback to watch reverse picture playback.
@ Press and hold the SCENE SEARCH (+) button during
still picture playback to watch forward picture playback.
@ Release the SCENE SEARCH button to resume normal
still picture playback.
iF Notes:
@ The sound is muted during playback modes other
than normal playback.
@ During reverse picture playback there will be some
noise bands in the picture, this is normal and does
not indicate a malfunction.