Sanyo VPC-S1213 - Page 44

EN-43
3. If you select [Single] in the previous step, the
figure shown on the right hand side will appear.
 Select the image that you want to print with
the e / f buttons.
 Select the print number (up to 99) with the
c / d buttons.
 After selecting the desired image and
printing number, press the SET button to
confirm.
4. Select [Exit] with the c / d buttons, and press
the SET button.
5. Select [Print] with the c / d buttons, and press
the SET button to start printing.
6. The printing starts and the figure shown on the
right hand side appears.
 [COMPLETE] will be displayed temporarily,
reminding you that the printing procedure is
finished.
 If an error is detected during the connection
(i.e. a printer hardware problem) between
camera and printer, [PRINT ERROR] will
be displayed.
 If an error is detected during the
communication (i.e. wrong setting on the
camera) between camera and printer, [ERROR] will be displayed.
 The image printing may fail if the power to the camera is cut off.
;;
00
;
;