EN-26
PHOTOGRAPHY MODE
[ ] Capture Mode
Your camera is equipped with a 2.5" full color LTPS-TFT LCD monitor to help you compose images,
playback recorded images/video clips or adjust menu settings.
1. Press the ON/OFF button to turn the power on.
J The status LED lights green and the camera is initiated.
J When the power is turned on, the camera will start in the
mode that was set.
J If the power is turned on at [ ] or [ ] mode, the
lens will extend forward and it is ready for shooting. At
both modes, if the mode switch is set to [
], the lens
barrel will retract into the camera body after 30 seconds.
J If the power is turned on at [ ] mode, the lens will
remain closed.
2. Slide the mode switch to [
].
3. Compose your image in the LCD monitor.
J Pressing the button zooms in on the subject, and
enlarges the subject on the LCD monitor.
J Pressing the button provides a wider angle image.
4. Press the shutter button.
J Pressing the shutter button down halfway automatically
focuses and adjusts the exposure, and pressing the shutter
button down fully captures the images.
J The focus area frame turns blue when the camera is in
focus and the exposure is calculated.
J When the focus or exposure is not suitable, the frame of
the focus area turns yellow.
J If the photographic preview is set to “On”, the captured
image will be displayed while the image is being recorded
onto the SD/SDHC memory card.
a
Press down halfway
b
Press down fully
To Next Page
Loading...
