Sanyo XH2672R User Manual

48 pages

To Next Page

To Next Page

Page #1 background image

Loading...

Page #1 background image

1

2

3

Save These Instructions!

1. RCS-SH80UG

(

Wired type: for all indoor units

)

2. RCS-SH80UA.WL

(

Wireless type: for X and T type indoor units

)

RCS-BH80UA.WL

(

Wireless type: for U type indoor unit

)

RCS-SH1UA

(

Wireless type: for K type indoor unit

)

3. SHA-KC64UG

(

System Remote Controller

)

85464189788001

©SANYO 2006

SANYO Electric Co., Ltd.

Gunma, Japan

Split System Air Conditioner

•

INSTRUCTION MANUAL

Indoor Units

Wall-Mounted type

KH2672R XH2672R TH2672R UH2672R

KH3072R

KH3672R XH3672R TH3672R UH3672R

XH4272R TH4272R

KHH2672R THH2672R

THH3672R

Ceiling-Mounted type Concealed-Duct type

4-Way Air Discharge

Semi-Concealed type

06-212 PAC-i_IM_Cover 4/12/06 7:14 PM Page 1

Table of Contents

Questions and Answers:

V
valenzuelaashleyAug 8, 2025
Why is my Sanyo Air Conditioner not cooling (or heating) properly?
- A
  Amanda HendersonAug 8, 2025
  If your Sanyo Air Conditioner isn't cooling (or heating) effectively, several factors could be the cause. First, try cleaning the air filter to improve airflow. Eliminate any heat sources in the room if possible. Ensure all doors and windows are closed to keep heat (or cold) out. Check for and remove any obstacles near the air intake or discharge port to ensure good airflow. Finally, adjust the thermostat to a lower setting for cooling or a higher setting for heating.
J
Johnny SmithAug 16, 2025
What to do if my Sanyo XH2672R does not turn on?
- K
  kentjenniferAug 16, 2025
  If your Sanyo Air Conditioner doesn't run, there could be several reasons: * There might be a power failure, so restore power. * The leakage circuit breaker may have tripped. In this case contact service center. * The line voltage might be too low, consult your electrician or dealer. * The operation button might be turned off, so press the button again. * The remote control unit or heat pump could be malfunctioning (if you see ERROR and characters such as E, F, H, L, P, etc., on the display), consult your dealer.
C
Catherine ReidAug 23, 2025
What does “CHECK” mean on my Sanyo XH2672R?
- T
  Tiffany LyonsAug 23, 2025
  If your Sanyo Air Conditioner displays “CHECK”, it indicates a trouble in the system. Contact service center.
H
hogantanyaAug 30, 2025
Why does the compressor on my Sanyo XH2672R Air Conditioner run then stop?
- A
  Alexis MurrayAug 31, 2025
  If the compressor in your Sanyo Air Conditioner runs briefly and then stops, it might be due to an obstruction in front of the condenser coil. Remove any obstruction that you find.

Sanyo XH2672R Specifications

General

Power Supply	220-240V, 50Hz
Air Flow	1200 m3/h
Type	Split System
Power Consumption	2600W
Operating Temperature	43°C
Dimensions	Outdoor: 800 mm

Summary

Product Information

Alert Symbols

Symbols indicating potential hazards or unsafe practices to users or the appliance.

Installation and Electrical Requirements

Safety Instructions

Crucial guidelines for safe operation and handling of the air conditioner.

Component Identification

Remote Control Unit Details

Identification and illustration of various components of the remote control.

Air Conditioner Operation

Adjusting Airflow Direction

Instructions on how to set airflow direction for different indoor unit types.

Special Operational Notes

Setting the Timer Functions

Guidance on setting various timer functions for automatic operation.

Maintenance and Troubleshooting

Care and Cleaning Procedures

Detailed steps for cleaning the air conditioner and its components.

Troubleshooting Common Issues

Common problems, possible causes, and recommended remedies for the air conditioner.

Energy Saving Tips

Advice on optimizing energy consumption and efficient use of the unit.

Wireless Remote Controller Overview

Alert Symbols

Symbols indicating potential hazards or unsafe practices related to the wireless controller.

Installation, Safety, and Unit Display

Safety Instructions

Crucial guidelines for safe operation and handling of the wireless remote controller.

Using the Wireless Remote Controller

Remote Control Unit Functions

Detailed breakdown and function of each button on the remote control.

Controller Operation and Special Features

Manual Unit Operation

Procedures for operating the unit manually when the remote is lost or not working.

Timer Settings and Troubleshooting

Troubleshooting and Energy Saving

Common problems, remedies, and tips for efficient use of the unit.

System Controller Product Information

Alert Symbols

Symbols indicating potential hazards or unsafe practices for the system controller.

System Controller Installation and Safety

Safety Instructions

Crucial guidelines for safe operation and handling of the system controller.

System Controller Usage and Functions

Controller Button Functions

Detailed explanation of each button's function on the system controller.

System Controller Display and Operation Modes

Starting Group Operation

Steps to operate multiple units simultaneously in a group.

Starting Collective Operation

Procedures for operating all units or units within a specific zone collectively.

Related product manuals

Preview: Sanyo XHS1271

Preview: Sanyo XS1872

Preview: Sanyo XM18AAB

Sanyo SPW-X365H

Sanyo SPW-X185H

Sanyo SPW-XR483GH56

Sanyo SPW-XR253GH56

Sanyo SPW-XDR184GH56(A/B)

Sanyo SPW-XDR164GH56(A/B)

Preview: Sanyo CM1812 / KMS0912 (x2)

Sanyo CM1812 / KMS0912 (x2)