Sanyo XH2672R User Manual

2
2 - 7
Using the Wireless Remote
Controller
1. Press and slide the cover on the back of the wireless remote controller in
the direction of the arrow.
2. Install two AAA alkaline batteries (LR03). Make sure the batteries point in
the direction marked in the battery compartment.
3. Press the ACL button, then replace the cover. If you press it, the current
time, ON time, and OFF time are all reset to 0:00.
• The batteries last about six months, depending on how much you
use the wireless remote controller.
Replace the batteries when the wireless remote controllerʼs lamp
fails to light, or when the wireless remote controller cannot be
used to change the air conditionerʼs setting.
• Use two fresh leak-proof type-AAA alkaline batteries (LR03).
• In replacing batteries, follow the instructions as mentioned in the
sub-section ʻʻHow to Install Batteriesʼʼ.
• If you do not use the wireless remote controller more than 1
month, take out the batteries.
How to Install Batteries
ACL
button
Cover
ACL
button
Cover
05-368 PAC-i_IM_Sec2 12/7/05 4:36 PM Page 7

Sanyo XH2672R Specifications

General

Power Supply	220-240V, 50Hz
Air Flow	1200 m3/h
Type	Split System
Power Consumption	2600W
Operating Temperature	43°C
Dimensions	Outdoor: 800 mm