Connections and Setup
12
Network Connection
Your TV will require an internet connection to operate all functions. Data usage
charges may apply.
Please refer to your Internet Service Provider (ISP) for additional information.
To access the internet, you must subscribe high speed broadband internet service from your internet service
provider.
Your TV can be connected to your home network in two ways:
•
Wired, using the RJ45 (LAN) connector on the back panel.
• Wireless, using the internal wireless to your home wireless network.
Note: The following instructions are just the usual ways to connect your TV to the wired or wireless
have any questions about your home network, please refer to your ISP(Internet Service Provider).
Connecting to a wired network
To connect to a wired network:
1. Ensure you have:
• An ethernet cable long enough to reach your TV
• A router or modem with an available Ethernet port
• A high-speed internet connection
• An Ethernet (LAN) port on the back of the TV
2. Connect your ethernet cable to the router and to the
Ethernet port on the back of the TV.
3. Use the Network Settings
Connecting to a wireless network
To connect to a wireless network
1. Ensure you have:
•
A router broadcasting a high-speed wireless signal
•
A high-speed internet connection
2. Use the Network Settings
Built-in wireless connection
Router
Ethernet
Port on the
back panel
TV Set
TV Set
Wireless Router
Modem
Internet
Modem
or
ESD regulation
This apparatus meets ESD performance criteria.
In case the apparatus does not recover in Ethernet
connection mode due to electrostatic discharge, user
interference is required.
To Next Page
Loading...
