Saorview DXD7025SVC - Safety Information

Safety information
• Power o all devices during connection set-up to
prevent electric shock.
• Unplug the power adapter from the wall socket to completely
disconnect the product from the mains.
• Do not place sources of naked flames, such as lit candles,
on the product.
• Opening the product results in loss of warranty and can cause
electric shock.
• Condensation can be produced within the product, e.g. if the
product is brought from a cold to a warm environment. Wait
for about one hour before operating the product. Aer that
time, the condensation will normally have evaporated.
• The product has feet on its boom side. Since the surfaces
of furniture are made of very dierent materials that a wide
variety of care products are used on, we cannot exclude the
possibility of some of these substances or their ingredients
soening or otherwise damaging the feet. Place a non-slip mat
under the feet, as appropriate.
• If the baeries are not used for a long period, they should
be removed from the remote control unit. Replace the baeries
at least once a year to prevent them from leaking.
• Do not expose the baeries to extreme conditions or excessive
heat, for instance, radiators, sunshine, fire or the like. This will
result in an increased risk of leakage or explosion.
• Never try to reactivate used baeries with heat, charging
or other methods.
• Baeries must not be dismantled and short-circuited.
• When inserting the baeries, observe the correct polarity (+/-),
otherwise there is danger of damage.
WARNING: To reduce the risk of fire or electric shock,
do not expose this apparatus to rain or moisture.
WARNING: The baeries shall not be exposed to excessive
heat such as sunshine, fire or the like.
Do not throw baeries in the bin or on a fire. Make sure that you
dispose of baeries safely at a local recycling centre. You can also
recycle baeries at many supermarkets.
Your receiver’s power adapter requires a 100V to 240V AC ~
50/60Hz mains supply and is fied with a moulded plug. If the
plug or cable breaks or becomes damaged do not use the receiver.
Do not aempt to open or repair the power unit under any
circumstances, due to risk of electric shock.